SCX10 II UMG10 Unimog Full-Size Front Bumper

ScalerFab

Full-size Steel, welded front bumper for the Axial SCX10 II UMG10 Unimog
*Pictures depict optional add-ons. See below for additional mounting instructions.

Specifications:
-190mm wide
- Will not fit a bumper-mounted winch (this rig is specifically built for a servo winch)
- Steel construction - Hand Made/Welded.

- Mounts using existing holes in frame - does not mount like stock plastic bumper(s) (Longer hardware recommended- hardware not included- See Optional Bumper Hardware Pack available under Accessories)
***NOTE: Bumper brackets mount between frame and Front Body Post Receiver. - Body posts will need to be spread slightly to mount properly. Also, we recommend using a smaller body clip, as the stock ones will not completely clip due to bracket interference. Alternately, new holes could be drilled in the body posts perpendicular to the stock ones to allow the body clips to be pushed in from the front or back with no interference vs the side.

**Please Note: Our finish options provide a superficial coating and will scratch/chip under normal use. Pros/cons of each can be found below: -Flat Black: not as susceptible to chips -Rustoleum Truck Bed Coating: easier to touch up using a can of Rustoleum Truck Bed Coating, available at Home Depot or Lowes. -Raw Steel: We recommend a raw steel finish if you intend to coat with a harder finish on your own. Mountain instructions: We recommend removing any plastic cross-members and screwing directly into the frame rails with a nut on the back. For extra tight fit, use a dab of Shoe Goo or E6000 Clear Adhesive between the frame rail and the bracket, and screwing down tight with a nut, and let sit overnight. Recommend hardware mounting kits available at the top of the page as an optional add-on.**

Main pic courtesty of #westernparccrawlers on IG! #ScalerFab for a feature!