After-Market Chassis/Body? No Problem!We often get asked what bumpers will fit someone's custom body/chassis. Though we do not have every single set of after-market frame rails in-house, there is an easy way to determine which ScalerFab bumpers will be the best fit and finish for your build. The first things we ask customers to do is to measure from the top corner of the frame rails OUT to and UP to the body, in millimeters. This will determine which kind of brackets we'll need to use. If the body sits higher than the top...
Scaled Up w/ ScalerFab - Moab EditionNow that we have had time to decompress and start editing footage, we can officially say the first ever combination RC and Offroading adventure retreat, Scaled Up with ScaleFab, was a massive success! 16 enthusiasts came together from all over the county to join us on an all-inclusive getaway exploring Moab’s most iconic trails from behind the wheel of a real offroad Jeep! The event kicked off with a welcome reception for our arriving guests, which included sandwiches and snacks, beverages, a...
ScalerFab Team Driver Chris Leal puts the New ScalerFab Sand Ladders and Bumpers to good use!Out with the old and in with the new! ScalerFab products getting well used! This month we worked on a family member's RC and tested the new ScalerFab Sand Ladders! We started this morning off early with installing a new ScalerFab Prerunner Series Front Bumper, it was as simple as pulling off the old bumper, sliding on the new one with some new stainless hardware, and we were done. When we finished the install, we made sure everything was tied down and than headed out for a small crawl ...
ScalerFab Pre-Runner Front and Rear Bumpers with ScalerFab Team Driver Brett ZacharyScalerFab Team Driver Brett Zachary tells us all about his wonderful ScalerFab Pre-Runner Series bumpers! Lets talk, ScalerFab Pre-Runner Series. This is a custom built Pre-Runner Front bumper on my Class 1 rig. These are awesome bumpers, I really like the ends angled back for better approach angle. On the Class 1 rig the rules state that the front bumper has to be as wide as the windshield. No problem, just gave Troy the width I needed, and done deal. These bumpers are super tough, as you...
After-Market Chassis/Body? No Problem!
We often get asked what bumpers will fit someone's custom body/chassis. Though we do not have every single set of after-market frame rails in-house, there is an easy way to determine which ScalerFab bumpers will be the best fit and finish for your build. The first things we ask customers to do is to measure from the top corner of the frame rails OUT to and UP to the body, in millimeters. This will determine which kind of brackets we'll need to use. If the body sits higher than the top...
